View Full Version : Car won't rev
konaboi808
09-14-2014, 04:47 AM
Ok. So I picked up a project. 91 SE. When I got it the wiring was laid but not all connected. Hoses weren't connected car didn't run. Started to play with it. Got it to idle but once I press the gas it will almost die or it will die. Played with the timing n for the most part is on point. Dizzy kicked my ass for a while n wouldn't start. Now it starts idles up a lil to about 800 than sslowly drops down. Get to the point where it sputters n pops at a low rough idle then dies. New cap n roter. Any ideas or test points please.
goldens14
09-19-2014, 03:27 PM
Do you have any CEL?
konaboi808
09-19-2014, 04:36 PM
No but it's hard to say cuz the car won't run for longer than around 10 mins. It starts gettin real jump/lope on the idle than starts to choke its self out.
spiegel420
09-28-2014, 06:44 AM
iacv and maf.
konaboi808
09-30-2014, 03:25 PM
iacv and maf.
Can some show pics of the iacv, mainly if it's possible to jus clean. On my m3. I would jus spray it with cleaner n be good to go
konaboi808
09-30-2014, 03:27 PM
And I have 2 mafs. Wit both. While idling n unplugged. Runs rougher
konaboi808
09-30-2014, 03:28 PM
And wen i unplugged maf. Idle changes
goldens14
10-01-2014, 07:36 PM
If the maf was to blame, I think you'd have a code
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.