BW S366, BC 272 Cams, 1650cc Injectors, Nitrous + MORE!

[smbonn2005]

Everything is obro! Need money for the new project car!!!

Prosport EGT Gauge and Thermocouple - $80
http://i11.photobucket.com/albums/a190/smbonn/20140803_203449.jpg

Prosport Fuel Pressure Gauge w/ Sender - $45
http://i11.photobucket.com/albums/a190/smbonn/20140803_203514.jpg

Prosport Volt Gauge - $30
http://i11.photobucket.com/albums/a190/smbonn/20140803_203822.jpg

KA24DE Freeze Plug Set - $30
http://i11.photobucket.com/albums/a190/smbonn/20140803_203536.jpg

Beercan's -8AN Fuel Rail w/ standoff's for Xcessive Manifold - $120
http://i11.photobucket.com/albums/a190/smbonn/20140803_203633.jpg

Borg Warner S366 T3 .70 A/R - $900
http://i11.photobucket.com/albums/a190/smbonn/5f467bc4-0ddc-40d3-bc83-908791c39cf7.jpg

Brian Crower 272/272 Cams - $300
http://i11.photobucket.com/albums/a190/smbonn/Forums/102_1020.jpg

Supertech Dual valve spring w/ Ti retainer kit - $400
http://i11.photobucket.com/albums/a190/smbonn/20140624_152943.jpg

Eagle H Beam Connecting Rods - $320
http://i11.photobucket.com/albums/a190/smbonn/20140803_201513.jpg

Full ZEX Direct Port Nitrous Wet Shot Kit + Purge kit - $800
http://i11.photobucket.com/albums/a190/smbonn/20140803_202244_1.jpg

Braided Short Clutch Line - $35
http://i11.photobucket.com/albums/a190/smbonn/20140803_203317.jpg

Z33 Track front rotors - $80
http://i11.photobucket.com/albums/a190/smbonn/20140803_201432.jpg

Z32 Aluminum Rear Uprights with NEW Ball Joint Adapters - $120
http://i11.photobucket.com/albums/a190/smbonn/20140803_203013.jpg

Xcessive Upper Oil pan - $300
http://i11.photobucket.com/albums/a190/smbonn/Oilpan_zps568201d0.jpg

Used QR25 Cam Followers (would need slight machining to get valve tolerance to specs, but one piece) - $50
http://i11.photobucket.com/albums/a190/smbonn/IMAG0288-1.jpg

Behrman/Wise Square Type 1 Front Bumper (Doubt this will sell here but super rare and really expensive) - $1000
http://i11.photobucket.com/albums/a190/smbonn/IMAG0278.jpg

Used Rust free "JDM" S14 rear subrame - $100
http://i11.photobucket.com/albums/a190/smbonn/IMAG0191.jpg

Greddy Oil Filter Adaptor for Cooler - $80
http://i11.photobucket.com/albums/a190/smbonn/IMAG0130.jpg

S13 Front Sway Bar Link Kit - $20
http://i11.photobucket.com/albums/a190/smbonn/20140803_203238.jpg

Stock S13 Horns - $10 or free w/ purchase
http://i11.photobucket.com/albums/a190/smbonn/20140803_203258.jpg

KA'DE Starter - $30
http://i11.photobucket.com/albums/a190/smbonn/20140718_160410.jpg

KA'DE Front Cover Lower and Upper - $70
KA'DE Rear Main Seal Holder - $20
http://i11.photobucket.com/albums/a190/smbonn/20140624_153048.jpg

KA'DE Thermostat Housing x2 - $20
http://i11.photobucket.com/albums/a190/smbonn/20140624_153138.jpg

MSD Start/Retard Controller - $120
http://i11.photobucket.com/albums/a190/smbonn/20140803_202338.jpg

MSD 2 Step Controller - $50
http://i11.photobucket.com/albums/a190/smbonn/20140803_202432.jpg

DSM Fuel Injector Resistor Pack - $30
http://i11.photobucket.com/albums/a190/smbonn/20140803_202706.jpg

S13 Driver Side Seat Belt Latch - $20
http://i11.photobucket.com/albums/a190/smbonn/20140803_202738.jpg

Stock FC RX7 Oil Cooler - $30
http://i11.photobucket.com/albums/a190/smbonn/20140624_153004.jpg

KA'DE Valve Guides - $50
http://i11.photobucket.com/albums/a190/smbonn/20140624_152854.jpg

Red OBX Pulley Set (No Crank Pulley!) - $80
http://i11.photobucket.com/albums/a190/smbonn/20140624_152828.jpg

S13 Door Speaker Adapters for 6.5" Speakers - $30
http://i11.photobucket.com/albums/a190/smbonn/20140803_203932.jpg

Turbo Oil Feed w/ filter from Oil Filter Housing - $10
-12 AN Aluminum Weld On Bung
http://i11.photobucket.com/albums/a190/smbonn/20140803_204002.jpg

S13 Shifter Surround - 1 Crack, is Pictured - $30
http://i11.photobucket.com/albums/a190/smbonn/20140803_204139.jpg
http://i11.photobucket.com/albums/a190/smbonn/20140803_204155.jpg

S14 Owners Manuals - Was with my old S14 ('95) and just kept them when I sold the car - $35
http://i11.photobucket.com/albums/a190/smbonn/20140803_204641.jpg

S13 Hatch Shell, no front fenders or bumper, has Megan Racing Coilovers. - $700
http://i11.photobucket.com/albums/a190/smbonn/20140701_141521.jpg
http://i11.photobucket.com/albums/a190/smbonn/20140701_141531.jpg
http://i11.photobucket.com/albums/a190/smbonn/20140628_105507.jpg

[richmond82]

Intake Mani is KA Correct?

[Xaser]

goodspeed radiator shipped to 33146? plus oil cooler FCRx7 ?

Ty

[hooligans661]

What brand is that z32 to z33 brake adapter and how much with shipping to 93215?

[ZX_240]

Yoo would u sell the q45tb seprate?

[smbonn2005]

PM's sent!

[7RIFT0]

If sale falls through for intake manifold let me know how much you are asking.

[d_nice]

good parts here

[hooligans661]

Caliper adapters sold to me!!! ;]

[double zero]

I like that bumper

[hooligans661]

Has the intake mani been sold yet??

[s14sfreakaleak]

did you sell the intake??

[ein024]

i lied your in bham?
can i get that starter sometime this weekend?
im in ferndale..