Saving Power FC settings through Commander

[bigturbo3]

New to the Power FC here, so sorry if it is a dumb question. I am changing my settings via the commander for my injector percentage. How do I save these settings. Once configured to 66%, the only option I have is to click Prev. If I do that, and go back into it, the values are back to default, not at 66% where I left them. Is that expected or should they still show as 66%

[bigturbo3]

Does anyone have thoughts on this? I was able to get my datalogit hooked up. What is the best way to verify the settings changed are saved? I am assuming you would make the changes, Write All, and then Read All to make sure they are the same?

[e1_griego]

That's the way to confirm the changes were applied, yes.

Usually if a PFC isn't saving the tune there is some sort of wiring problem.

[bigturbo3]

Awesome. Thank you