PDA

View Full Version : Driveshaft help


csimp3
05-16-2014, 12:50 PM
Ok, I have searched and cannot find the answer I am looking for. I bought a one piece aluminum driveshaft, and te guy told me it's for an s13, once I got it to the car I realized it's for an s14, a shop here in town can cut and resize it to the correct length, but since I don't have a stock driveshaft, I don't have those measurements, the say it's center of the c clip to center of the c clip, anyone have those measurements? Or is it better to just sell this one and buy an s13 driveshaft? In a hurry to have it, and will have a total of $275 into it with resizing

anti tyler
05-16-2014, 12:53 PM
Just sell it on here and get the correct one.

I wouldn't let a shop mess with chopping up a perfectly good drive shaft.

csimp3
05-16-2014, 05:31 PM
Don't have the money for a new one right now, and all these local guys seem to want $100 for a stock one

csimp3
05-18-2014, 01:20 PM
Anyone happen to have a driveshaft they can measure for me? Would be greatly appreciated!

Memberofthe600hpkaclub
05-18-2014, 01:24 PM
They should be able to figure out c to c if you get them the diff flange face to rear seal on the trans length

Memberofthe600hpkaclub
05-18-2014, 01:25 PM
Basically they would then just subtract the length from the yolk and flange and adjust I the end play...easy cheesy

jr_ss
05-18-2014, 06:50 PM
The FSM has the driveshaft lengths. The measurements are also on the internet, look for them.

Oh look, a 5sec search yielded these results. Look harder next time.

http://www.240sxforums.com/forums/nissan-240sx-f-q/117962-driveshaft-lengths.html

csimp3
05-19-2014, 08:37 PM
I had searched and found that same page, but is the center bearing included? Does it add to the length then? I'm just lookin for a solid answer cause I'm having a hard time finding one