WTB: ORC throw out bearing

[MeanS14]

Looking for a new throw out bearing for my ORC twin plate


Let me know if you have one

[nissan1310]

same as CC clutch its like $60

[MeanS14]

same as CC clutch its like $60

Have a link?

Twin plates use smaller throw out bearings than OEM Sr ones

I have heard ORC uses the same TOB as other twin plates on the market but can't confirm it

RhdJapan used to sell the ORC bearing and sleeve together but are no longer available though them

[GabeS14]

Have a link?

Twin plates use smaller throw out bearings than OEM Sr ones

I have heard ORC uses the same TOB as other twin plates on the market but can't confirm it

RhdJapan used to sell the ORC bearing and sleeve together but are no longer available though them

not sure if it's the same as my old Blitz, but it was the same as the 06 350z when cross referencing part numbers, took me 2 months to figure it out and tons of research since it was a discontinued clutch.

[MeanS14]

not sure if it's the same as my old Blitz, but it was the same as the 06 350z when cross referencing part numbers, took me 2 months to figure it out and tons of research since it was a discontinued clutch.

Gabe, both the throw out bearing and sleeve from the 350z? Or just the bearing?

[Dirtcanhurt089]

I have a brand new orc tob for an Sr 409d single plate idk if they are different but its fucking expensive either way

Sent from my HTC One using Tapatalk

[Dirtcanhurt089]

Cost me 135$ plus shipping I'll do 135 shipped fuck dealing with rhd they sucked fpr customer service

Sent from my HTC One using Tapatalk

[MeanS14]

I have a brand new orc tob for an Sr 409d single plate idk if they are different but its fucking expensive either way

Sent from my HTC One using Tapatalk

They are not the same. Twin plates use a smaller TOB to make up for the added thickness of the additional plate

[nissan1310]

I have both clutch they both use smaller bearing and its the same here's the number to cc clutch 800.809.6598 call them monday

[nissan1310]

just tell them u want a throw out bearing for sr20det with twin plate clutch i just bought one not to long ago it was $60

[silvia910]

I have an orc twin plate also and just ordered the tob and sleeve from frsport. It worked fine but my slave cylinder almost overextends when clutch is fully depressed. Hasn't blown out or started leaking yet. Apparently they said it should work for our clutches.

[GabeS14]

Gabe, both the throw out bearing and sleeve from the 350z? Or just the bearing?

Lemme try to find my old thread....also it should be about $40-60 bucks max.