HKS Dogbox Question

[MeanS14]

I recently purchased an HKS 6speed sequential dogbox and am trying to figure out what driveshaft to use with it

I have tried a stock Ka/Sr driveshaft, as well as a z33 and rb25 driveshaft. None of those work, either the slip yolk diameter is too big or too small

Can a driveshaft shop just build one based on the number of splines and diameter of where the driveshaft slips into the trans?

[rwtf]

why not call and ask them.... facepalm....

[Bubba]

If it's a dogbox then it uses a common setup on the ass end that any driveshaft shop should be able to work around. If they say or act like they can't, drive away fast as fuck.

[xska]

It uses S15 6 speed drive shaft.

[ultimateirving]

I recently purchased an HKS 6speed sequential dogbox and am trying to figure out what driveshaft to use with it

I have tried a stock Ka/Sr driveshaft, as well as a z33 and rb25 driveshaft. None of those work, either the slip yolk diameter is too big or too small

Can a driveshaft shop just build one based on the number of splines and diameter of where the driveshaft slips into the trans?

Look for Phoenix rack and axle. Great shop good prices. Custom driveshafts around $250. Got mine made last month. Steel shaft z33 yoke and s13 flange. YOu should be able to count the splines and measure the diameter. Or see what hks lists as the output size