Pirate117
02-21-2014, 07:29 PM
A couple days ago I pulled off my valve cover to put in a new gasket, when I was pulling the hosing off of the T piece that goes to the oil catch can the hose cracked.
(Showing the area I attempted to describe)
http://i.imgur.com/NkfJMg0l.jpg?1
I thought no problem just go get some new hose, as I went to go measure length I noticed a brass looking filter/valve.
http://i.imgur.com/JH7wPGBl.jpg?1
I'm not entirely certain as to what this is for and if I need a new special kind of hose with whatever this is in it, if I can just get it out of the old hose and put it into the new one, or just put the new hose in without it.
Thanks in advance, any advice/knowledge would be greatly appreciated.
(Showing the area I attempted to describe)
http://i.imgur.com/NkfJMg0l.jpg?1
I thought no problem just go get some new hose, as I went to go measure length I noticed a brass looking filter/valve.
http://i.imgur.com/JH7wPGBl.jpg?1
I'm not entirely certain as to what this is for and if I need a new special kind of hose with whatever this is in it, if I can just get it out of the old hose and put it into the new one, or just put the new hose in without it.
Thanks in advance, any advice/knowledge would be greatly appreciated.