PDA

View Full Version : NC RB25 Greddy intake manifold


skis240sux
01-21-2014, 08:58 AM
RB25 Greddy intake manifold.

Started to polish it but lost interest

$950

$1000 with Q45 TB 65695

skis240sux
03-14-2014, 10:21 PM
Back to the top

smoked240
03-14-2014, 10:24 PM
Uhh not to be a dick but this looks like an Isis manifold or maybe even an eBay piece..that's most defenitly not a greddy intake..authentic greddy might be worth $900. For this piece eBay sell them for 200. And Isis new is like 4-450..

skis240sux
03-14-2014, 10:25 PM
It's a greddy bought straight from greddy. Doubt they shipped some eBay junk to a customer

smoked240
03-14-2014, 10:32 PM
Just from the looks of it and the angle of the top vacuum ports seems off. But it's easier to tell in person. You should have proof then if someone is concerned? Still not a bad intake. Glws!

skis240sux
04-10-2014, 06:11 PM
Bump been gone swhile

skis240sux
04-17-2014, 05:50 AM
Inbox clean

skis240sux
04-23-2014, 05:19 AM
Bumpin........

a-s-silvia
04-23-2014, 08:22 PM
I have $250 for it

skis240sux
04-24-2014, 05:58 AM
I have a factory one for $250

skis240sux
04-28-2014, 05:45 AM
Going to sand blast her and powdercoat it

skis240sux
05-09-2014, 09:14 PM
70729

Powder coated it black


Sent from my iPhone using Tapatalk

skis240sux
05-10-2014, 06:32 PM
One sexy beast


Sent from my iPhone using Tapatalk

skis240sux
05-12-2014, 04:16 PM
Sleek looking bitch

skis240sux
05-14-2014, 05:22 AM
$850 shipped

redjet
05-21-2014, 10:14 AM
will you sell just the throttle body?

skis240sux
06-09-2014, 06:30 AM
Yes I will

skis240sux
06-16-2014, 02:30 PM
Still here

a-s-silvia
06-16-2014, 02:51 PM
Give you $250 for itStill here

skis240sux
06-16-2014, 02:52 PM
Wasted post

skis240sux
06-16-2014, 03:51 PM
$700 shipped on this

skis240sux
06-18-2014, 06:57 AM
Had a lot of people asking so here's the story..... We got this directly from greddy not threw. Middle company. We started to polish it and that's when we were deployed. We side tracked the project after that.

Since I'm selling it it is easier to powder coat the manifold rather then polish it so that's what I did.

This manifold is a heavy cast piece not some cheap knock off material. The coolant ports are nice and square and the flange has never been touched to make it true.

Phlip
06-18-2014, 07:41 AM
Too many bumps
:lockd: