s14 front wheel studs.

[ankyle62]

i read that the arp studs will not work on the s14 front because the require a larger knurl(.560), which the moroso provides. is this correct? can i use the arp or do i have to get moroso or other brand? if i do, what is a good site to get them from?
i searched but found only a few comments on this and wanted to confirm before i returned the arp ones for the front. thank you.

[WilloW]

The Moroso knurl is a bit bigger but they will work with some minor grinding IIRC. I think Ace uses them on his car.

[ankyle62]

The Moroso knurl is a bit bigger but they will work with some minor grinding IIRC. I think Ace uses them on his car. but is the bigger knurl required?

[ankyle62]

anyone? :mepoke: i know you s14 people dont all have stock studs. :mepoke:

[AceInHole]

anyone? :mepoke: i know you s14 people dont all have stock studs. :mepoke:

The Moroso knurl is a bit bigger but they will work with some minor grinding IIRC. I think Ace uses them on his car.

They should even be able to be pressed in with a good hydraulic press, although I'd rather do some "minor" grinding.

I know everyone is going to skip this line:
This is my hub after sitting out for a week after I crashed my black S14, with the Moroso studs:
http://www.engr.uconn.edu/~corrales/carsIM/studs_0.JPG

I run ARP's in the rear, which unfortunately use a differen't thread size.

[ankyle62]

ok and with 5 lug and 4 lug, no difference right? i already have the apr because i was not aware of the difference, so now i have the extra studs and different sizes nuts :wtc: .

and i shop wouldnt look at me stupid if i told them to put them in. they wouldnt say they are the wrong size or anything? because it sounds like a pain in the ass to do. the rears i will do though.