PDA

View Full Version : Installed walbro fuel pump RB20 car wont start HELP!


bboyclo
11-30-2013, 11:25 AM
I have searched all over the internet and could not find an answer :sad: So yesterday i went to go install the walbro pump. when I pulled out the old one I noticed that the BLACK wire had a RED wire spliced on it and the RED wire had a BLACK wire spliced on it. So I didnt really pay too much attention to this so I matched BLACK TO BLACK AND RED TO RED with the wires that came with the kit. As soon as I turn the key to on the 15A fuse for the fuel pump blows. So a buddy suggested maybe the wires were supposed to be switched like how i had found it when I pulled out the old one. So i pull out the fuel pump again and switch the wires BLACK TO RED AND RED TO BLACK. turn the car to on the fuel pump primes and doesnt blow the 15A fuse but the car still wont start. I have ran out of ideas and really need some help/input. Needs more gas? my gas is below 1/4 but theres gas in the tank. EGI PUMP relay went bad when I kept blowing 15A fuses? I really dont know guys someone help me PLEASE!!!

bboyclo
12-01-2013, 12:18 PM
nvm problem solved

garrettanda
12-01-2013, 09:17 PM
what was it? just curious