RB25det MAF options

[redline racer510]

mods
S14 rb25det s1 swap (stock)
greddy intake manifold
custom t3 turbo manifold
Tial 46mm wastegate
Holset hx35
top feed 850cc bosch injectors
aeromotive FPR
3-inch exhaust
nistune type 2
Target HP 400~
blah blah blah etc......

I want to run a blow through MAF and have googled around for some info and opinions and for the most part there is mixed feelings about running them. I would like to run a blow-through n62 but want to know what you guys think and any better alternatives if there are any. The main reason I want to go blow through is cleaning up the amount of piping near the turbo(vac lines,IC piping,BOV recirc pipe,etc).

[foreverdeath]

i have yet to go ka-t but i plan to go blow thru when i do it. havent read much problems about blow threw execpt the top of the maf popping of at high boost. if you got the money and want clean setup you could get a cobra slot maf they make a plate so you can weld it into a charge pipe. you actuly place it out of sight just by putting it on the bottom or unseen section of pipe.
http://imageshack.us/a/img189/1713/cimg4244o.jpg
http://vmptuning.com/pics/SLOTMAFalberto.jpg

[redline racer510]

Do you have experience any thoughts about the quality and accuracy of ford lightning MAFs? Was actually thinking about this and even made a thread about it but didn't receive much response except someone saying they would rather go with a n62 but these MAFs are cheaper and easier to find and support much higher HP than the n62 does.
http://thumbs3.ebaystatic.com/d/l225/m/mOqjLjIQQqEP7g4Eu7l1nuw.jpg

[foreverdeath]

I have not read into them at all sense they are out of my current budget and power goals. im just planing a simple junkyard (execpt for a few peices) t28 ka-t blow threw setup which i will proably get the n60 maxima maf once i overflow the stock one. if i had the choice id do it over a n60 or n62 solely cause its very clean set up, you could make it look like you running a MAP setup just by placing it right.

[redline racer510]

My tuner is recommending the MAP ecu3 so I can just run map instead of maf. What you guys think?