heater not heating

[aga]

sup guys. searched around, didnt find anything.

so, the wire that was turning the cold-hot air door was bent, took out the switches and straightened it, added some wd40, works fine now, but no heat is coming out of the vents. could it be something else? heater core clogged or something electrical?


i gotta fix this because

http://a.tgcdn.net/images/products/additional/large/efe0_winteriscoming.jpg

[zerodameaon]

There is the little flappy air diversion door to adjust where air flows but there is also a valve up on the core that needs to be connected in one way or another to that door.

The rod dead center is probably off and its stuck on cold(closed).
http://imagehost.vendio.com/a/18937703/aphotoalbum/1225655787016_IMG_0049.JPG

http://images56.fotki.com/v371/photos/4/47612/3915226/IMG_7075-vi.jpg

[aga]

that little spring next to the neck up top ?

ok, got it ...i hope i can reach and not have to take out the dash... THANKS!

[Mikester]

If I read that right- It's the rod that goes to the blend door... That's the door that cycles between warm & cool.

[zerodameaon]

There you go thats the name, could not remember it at 4am.