PDA

View Full Version : 95 zenki just installed new window motor but doesn't work


vuez10
09-21-2013, 09:51 PM
I just installed a new driver window motor and it goes down but doesnt go up I checked amp, and wires all good, could it be that they gave me a passenger motor ?

idlafie
09-22-2013, 02:29 AM
Try disconnecting the wires running to the motor & powering the motor directly from a 12 volt power supply. If the motor works, then reverse the polarity on the wires & see if the motor operates with the wires reversed. If the motor operates up & down, then the motor is okay and your problem could be with your switch or your power window amp.

The power window amps are notorious for broken solder joints. You might want to take apart the amp & double check the solder joints on the circuit board. Take a soldering iron & heat up the solder on the board to make sure the contacts are properly soldered to the board. If they are, then take a voltmeter/continuity tester & check the power window switch. Those can go bad also.

Anyhow, hope this helps. Good luck!!

ID

vuez10
09-22-2013, 01:41 PM
Well does it mean that the motor is the wrong one cuz my window is super easy to push down

jlopez7354
09-22-2013, 06:35 PM
My cars passenger window was like that I would be trying the switch for minutes before the window would go up I swapped out the switch and it works fine now

vuez10
09-22-2013, 06:47 PM
But was it easy to push down

sleepyS14se
09-24-2013, 10:25 AM
bad window switch