rx7 lug pattern

[YoungRookie]

What is the lug pattern of the 4 lug turbo ll rx7's? If they are 114.3 i can get a good deal on them from one of my buddies here in town. thanks in advance

[NismoSilvia270R]

rx-7 turbo II and gtu and gxl are all 5lug

[thelinja]

1. There were no 4-lug TII wheels. Only base model S4's(86-88) were 4 lug. The lug patterns are 4x114.3 and 5x114.3.

2. The center bore on RX-7 wheels is too small for the 240SX hubs, therefore, the wheels will not fit.

[richardxfeng]

sorry for hijacking the thread.i was wondering if Mazda have same size wheel nuts as toyota?thanks!

[DRFT]

86 have 4x114

sw20 have 5 x 114

[SilviaDriver]

RX7 = 240sx?

if so, then this is the correct section =]

[YoungRookie]

Okay ig uess the car was not a turbo ll i was told it was, but i saw the wheels and they are 4 lug, but they will absolutley not fit?

[thelinja]

Unless you bore the center a few mm's, no they won't fit.

[boro240]

also, do FCs have the same offset as FDs? cause FD wheels are +50.

[thelinja]

All FC wheels are +40.

[richardxfeng]

86 have 4x114

sw20 have 5 x 114

i was alking about wheel nuts size,not the bolt pattern.

[DRFT]

i dont think so, only nissan and subaru share the same pattern. the rest is honda toyota and others i tihnk

[YoungRookie]

How hard would it be to bore the center out a few mm's? or how much would it cost to get done?

[thelinja]

Boring out the center of a wheel seems like a pain in the ass. I suppose you could use a dremel with a carbide bit, but it would be hard to get it uniform. What wheels are these anyway? Because the only 4 lug FC wheel I can think of is the phone dial looking one and that wheel is 14x5.5".

[YoungRookie]

The wheels look like the watanabe rs8, i have seen these on a 240z before too and they look good.I dont think they are stock rx7 wheels

[thelinja]

Well, if it isn't a stock Mazda wheel, you should test fit it because chances are the center bore would fit the 240 hub.

[mav1178]

Boring out the center of a wheel seems like a pain in the ass. I suppose you could use a dremel with a carbide bit, but it would be hard to get it uniform. What wheels are these anyway? Because the only 4 lug FC wheel I can think of is the phone dial looking one and that wheel is 14x5.5".

Any machine shop with a CNC machine can bore the center of a wheel out. You'd need it at least 66.1mm for a Nissan center bore.

-alex