PDA

View Full Version : Anyone burning chips?


Chuki_Silvia
09-02-2013, 04:24 AM
Hey everyone, Stock 93 SE ka24de here-

Just doing a simple t25 n60 370cc moates board setup and was wondering if anyone with a burner could burn me a chip. Obviously I, everyone and their mom have that file and some chips, so I'm just trying to save the cost of actually buying a burn 2.

Sorry in advance if their is already people on here readily advertising this service, I searched first swear!

Croustibat
09-02-2013, 06:10 AM
buy an eprom burner, cost may be around 20$

cotbu
09-02-2013, 11:02 AM
I could help you out with that, but your in florida and I know there's someone closer to you that should/could help you out.
If you can't find anyone closer hit me up.

Chuki_Silvia
09-02-2013, 06:17 PM
buy an eprom burner, cost may be around 20$

Are there really one that are that cheap? I was searching for a while and the best I could come with that was compatible with the ST chips nissan uses was like 80, was a willamete (I'm spelling that wrong I'm sure) which is also how much a burn 2 cost's.

If you could provide a link to something you know would work with those chips that would be great. I even kept a really old pc tower with serial port around just in case I could find a cheap one.

Chuki_Silvia
09-02-2013, 06:30 PM
I could help you out with that, but your in florida and I know there's someone closer to you that should/could help you out.
If you can't find anyone closer hit me up.

Since you offered I think I will take you up on it. Sure I live in FL, but like I said in my introduction (no one reads those, I know) I live in the part where they put pink illest stickers on Ford Rangers, not down south. .....There might be someone around here that is decent at tuning KA 240's but I can't find them.

cotbu
09-02-2013, 08:28 PM
the chips i currently have are SST 27SF512
so just send me all the info. And do you know if your board reads odd/even?
if not, you sending me all the relevant info, including the bin, and i could take care of it myself.
just pm it. or email [email protected]