Starts right up and can't go past 1k

[S13lazy]

Ok so yesterday I decided to check my tensioner on my 92 240sx
And when I put everything back on the car it started but as soon as
You give it has it cuts off or Boggs down. I checked my timing about
30 times so I know that's fine. What stresses me out is the car drove fine before
I decided to check the motor. I didn't touch anything or removed anything other than the dizzy, valve cover , and the cover for the chain.. Any help is greatly appreciated.

[S13lazy]

Still can't figure it out

[S13lazy]

Codes 11 cps
12 maf
34 knock sensor
35 egr temp sensor

[do it sideways]

Maf! Maf! Maf! Lol

[slidesquad240]

^what he said

[S13lazy]

I thought the symptoms of a bad maf was if it didn't go past 3k. But I'll have to check it out again tomorrow. Saw I had a leave from the egr tube

[Croustibat]

Car goes in limp mode when MAF is dead, meaning you cant go past 2500/3000rpm. IF the engine can reach that.

Your problem is at least one vacuum/boost leak, and/or broken maf.

[S13lazy]

Car goes in limp mode when MAF is dead, meaning you cant go past 2500/3000rpm. IF the engine can reach that.

Your problem is at least one vacuum/boost leak, and/or broken maf.



Yea I think it's the egr tube because its blowing out air by the headers. I just can't fix it today to find out because everything is closed. I might just delete the system

[S13lazy]

Well I still have the issue and my car is in tdc had just about 3 people come look at it..