240sx wire harness

[Kouki_s13]

I have a problem with the fender lining metal is chewing throw my tire. What do you guys do to get rid of it if your trying to go slammed so that that metal doesn't cut through your tire? And what to do with the wire harness help guys please.

[EvoVIII808]

Cut slits into it and bash it flt, or cut it out and replace it with a flat sheet of metal.
http://i323.photobucket.com/albums/nn450/s13kasleeper/87357cb5.jpg
http://knoop.sumospeed.com/wp-content/uploads/2009/11/build25.jpg

[Kouki_s13]

I'm trying to go stanced out on my 240 but I see my wire harness is getting chewed up by my tire what do you guys so that it doesn't rub?

[corkscrew]

http://zilvia.net/f/chat/407974-tucking-wire-harness-s13s-like-baws.html

[ChoeBoy]

Like corkscrew linked, tuck your wires up under the fender. You have to do both sides even if one side seems to be fine. Also what I did with the metal slit pointing down was heat it up a bit and take a huge ass hammer to it until it was flat. Good luck with everything man, it's an easy job but just takes a while.

[Reece]

Honestly I'd just run the harness through the bay. That tire chewing through it shit is just lame.

[lflkajfj12123]

relocate it into the bay