Slotting camber plates...

[t3chnique]

So I would like to slot my camber plates for more negative, they are the typical 1/4" thick aluminum camber plates that Megan/BC/K-Sport use.

What would be the best tool to use to notch the plates, mainly the larger middle hole where the top nut is (read: where you adjust the strut dampening to hard or soft) ?

I'm not looking to slot the upper hole in the bottom mount. A jigsaw and dremel are at my disposal.

TIA

[jr_ss]

Send them to a machine shop to be milled.

[Croustibat]

Dont slot them. The bearing that is right under cannot take more angle than what you already have (i dont think it can handle what you currently have, actually)