radiator support removal/install 96'

[Clicky]

Is it better to remove the entire radiator support and weld in a new one? Or remove only the pieces necessary. .

The support is bent inwards and cracked the cap of my radiator. Wtff lol

[soundboy]

Cut and replace the entire thing. You could even bolt it together with bolts and nuts.

Sent from my GT-P3110 using Tapatalk 4

[fliprayzin240sx]

Depending on how tweaked it is, you might be able to get away with pulling it back to place.

[Clicky]

Yea I was thinking about just pulling it back at a body shop. .

But! Itll never be the same. ..

[fliprayzin240sx]

Like I said, all depends on how bad it is. Mine shifted a few inches in after getting clipped. I managed to save it by hooking a tie strap to it and pulling it out to align it.

[Clicky]

Yeaa.. oh well.. I already went ahead and bought a new one. I dont want it to look bent even if its pulled to alignment.. i'll pull out the reinforcement bar tho .

Gonna get it welded on wednesday if not then thursday....

Any tips?