S13 pbm subframe riser problem help!

[Your240sucks]

Nevermind……..

[pacotaco345]

Mine slid right on, but you have to make sure the subframe is lined up perfectly when you shove it up there. I had myself and two others helping guide it in. Remember there's no play in the bushings anymore so if its not perfect it will bind. Also make sure your bushings are actually pressed in all the way.

[huffandpuff00]

put the jack on that spacer and use a rubber hammer to jolt it loose. us some wd40 to help it. good luck!

[Your240sucks]

Thanks guys for a cool response!!



And Yes I had 2 people helping me as well.
To align it perfect I only left 2 bushings on the front ones (closer to rear bumper).. And lift it up.
Then I slid the 2 back bushings in and went straight through the studs. The driver side remain unleaded and bringing another jack would only cause the car to lift up.

I'm going to bang the sh#t out of my chassis tomorrow and see if it was truly the subframe hitting on the subframe since it did go up half an inch.

[Your240sucks]

just to get an update on this thread for future purpose on people that might have same problem.
They are on!!!!!!!!!!

I had to bent the chassis to make the subframe have enough room to go up.
If any similar problems pm me ill be more then happy to answer few questions with my experience.