z32 calipers wont fit

[Clicky]

So i got some z32. 30Mm. Calipers for my s14.
I bought some 30mm rotors from autozone. And for some reason the rotors hit
The inside of the calipers... dont know what to do, i thpught it was a direct fitment.


When off the car the rotors fit into the calipers just fine.

It only begins to rub where the rotor sits in between the caliper when i tighten the caliperbolts .

And i even measured both caliper and rotor. Both 30mm with some change

[Chaluska]

then your not doing something right.

[Clicky]

Removed the splash shield...

2 bolts for the caliper.... nothing else to do

- _______-

[genericforumname]

you might want to post pics of the calipers. you might have ended up with some of the non-30mm ones. the interior should have about 2mm of clearance with the rotor if I remember correctly.

[Clicky]

I measured where.the rotor is supposed to sit in the caliper and it measures out to 30.1?mm

i had to make them fit on the car. With some modifications. .

Ill post some pics tomorrow. This phone doesn't let me lol

.And im pretty sure the 26mm calipers measure 26.?? Not close to 30mm i would think...

[dawagarage]

26mm z32 brakes
rotors measure at 26mm, but the calipers
are actually 30mm.

sounds like you might have 26mm calipers.
http://importnut.net/240pics/brake_upgrade/caliper/calipercompare09.jpg
http://importnut.net/240pics/brake_upgrade/caliper/calipercompare02.jpg

read up on it all here
The Definitive 300ZX Brake Swap Paqe (http://importnut.net/300zxbrakeswap.htm)

[Mikester]

Or the genius at Vatozone gave him rotors other than what is actually needed... Other than conversion lines & trimming or getting rid of the dust shields, no modifications should be needed.

[Clicky]

26mm z32 brakes
rotors measure at 26mm, but the calipers
are actually 30mm.

sounds like you might have 26mm calipers.
http://importnut.net/240pics/brake_upgrade/caliper/calipercompare09.jpg
http://importnut.net/240pics/brake_upgrade/caliper/calipercompare02.jpg

read up on it all here
The Definitive 300ZX Brake Swap Paqe (http://importnut.net/300zxbrakeswap.htm)

Ahhhh shit.. your right... i measured exactly right there and got the same thing.. thanks for the help guys