nissanguy93
07-01-2013, 07:41 PM
Hello all, im parting out my built sr20det due to it jumping time and dropping a valve in cyl 2.
Lots of good parts here and under 10k on build. Im going v8 so stuffs gotta go. May consider trades for 5 lug, z32 calipers, s13 suspension stuff, lsx stuff, s13 front fenders, single cam harness, seats, about it. Text 540_257_0703 for pics of anything until i can figure out why i cant upload from my phone.buyer pays shipping. Offer up obo.
-bc 272 cams with chipped exhaust side cam( in rear after last lobe,not sure if its good but still ran in car. Intake side fine-$120 for the pair
- new tomei adjustable cam gear $60
-port/polished head with brian crower titanium valve springs with retainers still installed. Dropped a valve on cyl 2, unknown condition of other valves. $250 will seperate
- sr20det arp head studs $80
-86.5mm cometic 3 layer head gasket used but in gc.(they are reusable)$40
-greddy rocker arm stoppers $50
-new aftermarket sr20det tensioner- $60
-sr20det assembled block fully balanced with CP 86.5mm forged pistons,rings,and eagle rods. Cyl 2 piston has some marks on the topfrom a valve so not sure of its still good butcan buy them individually. Acl bearings ect. Complete short block with oil pan. $600
Can separate for right deal.
-complete set of rocker arms with guides/shims $80
- coil packs with harness $80
-injectors/rail $120
-intake mani w/ throttle body$60
-notchtop valve cover( needs paint and back left bolt hole broken but doesnt leak) $40
Make offers, need this stuff gone.
Lots of good parts here and under 10k on build. Im going v8 so stuffs gotta go. May consider trades for 5 lug, z32 calipers, s13 suspension stuff, lsx stuff, s13 front fenders, single cam harness, seats, about it. Text 540_257_0703 for pics of anything until i can figure out why i cant upload from my phone.buyer pays shipping. Offer up obo.
-bc 272 cams with chipped exhaust side cam( in rear after last lobe,not sure if its good but still ran in car. Intake side fine-$120 for the pair
- new tomei adjustable cam gear $60
-port/polished head with brian crower titanium valve springs with retainers still installed. Dropped a valve on cyl 2, unknown condition of other valves. $250 will seperate
- sr20det arp head studs $80
-86.5mm cometic 3 layer head gasket used but in gc.(they are reusable)$40
-greddy rocker arm stoppers $50
-new aftermarket sr20det tensioner- $60
-sr20det assembled block fully balanced with CP 86.5mm forged pistons,rings,and eagle rods. Cyl 2 piston has some marks on the topfrom a valve so not sure of its still good butcan buy them individually. Acl bearings ect. Complete short block with oil pan. $600
Can separate for right deal.
-complete set of rocker arms with guides/shims $80
- coil packs with harness $80
-injectors/rail $120
-intake mani w/ throttle body$60
-notchtop valve cover( needs paint and back left bolt hole broken but doesnt leak) $40
Make offers, need this stuff gone.