Low friendly downpipe circuit sports moonface copy 280.00 shipped to the lower 48

[lok]

Oval one piece downpipe. Includes divorced o2 housing.

280.00 shipped to the lower 48

PM for contact

http://i97.photobucket.com/albums/l208/aukalok/forsale/100_2016_zps0a32339a.jpg

http://i97.photobucket.com/albums/l208/aukalok/forsale/100_2019_zpscf2f2c0b.jpg

http://i97.photobucket.com/albums/l208/aukalok/forsale/100_2018_zps8715eb2c.jpg

[brndck]

i have the same one and its rad. sits completely above the frame rail.

[lok]

i have the same one and its rad. sits completely above the frame rail.

Yup. Frame rails will hit before the down pipe will.

[Seraphim38]

Man I wanted one of these for so long. Now I have a custom fabricated downpipe that integrates my turbo dump tube via flex pipe, or I would buy this in two seconds. Free bump for a great part.

[dawagarage]

cool.
oval piping is so expensive, even if you were to buy it by itself

[Big Zee]

Circuit sports makes these!!! when I have pennies I need this!!

[zbarsuglia]

3 inch?
Msglength

[gostrider]

Nice part...is a flex pipe really needed?

[lok]

3 inch?
Msglength

It is three inch where it bolts to the test pipe.

Nice part...is a flex pipe really needed?

I had it installed and daily drove the car for 2 years and when I took it off, all 5 bolts were still tight and the four on the turbo were still tight.

[white-s13coupe]

will this fit my ka-t 28 ??? lemme know

[jr_ss]

will this fit my ka-t 28 ??? lemme know

It's for the SR motorset with bottom mount turbo's.

[hobbs]

Circuit sports makes these!!! when I have pennies I need this!!

They no longer make them, they were discontinued right around the same time that the MoonFace DP was discontinued. Awesome downpipe, finally tossed mine on my car and actually made the buddy club pretty quiet.

[slow_sr20]

i too have one and love it. Don't sleep on this people. Bump for a sweet part.

[alwyzDTF]

I want it. pm has been sent.

[dtfdanyo]

does this work with Tomei Expreme manifolds?

[zbarsuglia]

It's for the SR motorset with bottom mount turbo's.

My kat is bottom mount 2871. Are you saying it will or won't fit. I'm really Interested seeing that my car is super low

[jr_ss]

My kat is bottom mount 2871. Are you saying it will or won't fit. I'm really Interested seeing that my car is super low

If the turbo is relatively in the same location or lower than an SR's, then yes it will fit. However, I think it's location is higher in the engine bay and it will hit the floor pan. This thing sits extremely close to the floor pan on a SR setup(within .25" or less) and was not mentioned in the original post.

[brndck]

I am not running a flex pipe and do not have any issues with bolts coming loose or gasket issues. My exhaust bushings all have hose clamps on em so it's held pretty tightly.

[alwyzDTF]

money sent. its MINE haha