Jersthecool
06-11-2013, 05:55 PM
I've had an autometer water temp gauge in my car that never had the sensor installed and I've found the replacement one I need to buy and the thread pitch is 1/8" and I'd like to install it directly into the bleeder valve on the water inlet if possible as I don't want to go and buy an adapter and cut my rad hoses to install it. If the thread isn't the same anyone know if it's possible to re-thread the sensor to the thread of the bleeder valve?
This is what the sensor is btw
http://www.autometer.com/cat_accessoriesdetail.aspx?vid=33
This is what the sensor is btw
http://www.autometer.com/cat_accessoriesdetail.aspx?vid=33