Log in

View Full Version : S14 gauge cluster won't work need help/advice


Artie
06-08-2013, 02:46 PM
So I need some help. Where can I start searching for the problem. My cluster was working before and all of a sudden it stopped working. It still lights up. But the speed,RPMS,gas,and temp won't read at all. And the ODO doesnt read aswell. I've searched around forums but they all keep saying to check the fuse but I've checked all fuses and they all seem fine. Any help is appreciated :) thanks

Artie
07-27-2013, 06:58 PM
bump bump bump

fliprayzin240sx
07-27-2013, 10:27 PM
Check the fuses in the kick panel. Should be one of the 7.5 amp fuse in the top right. If those fuse checks out, you need to check the wiring into the gauge. Check and make sure you're seeing 12v into the cluster. There is only 1 12v wire going into the cluster to power up the whole thing. If you're not getting it, nothing will work. I just cant remember which wire it is off the top of my head.

Alan_405
02-04-2014, 02:32 PM
I'm am having this same issue. I check the fuse and it was blown. Put another in it and it blew few minutes later. Put one last one in and it also blew. Never had an issue before with the fuse blowing. What could be making it blow,

FaLKoN240
02-04-2014, 02:34 PM
A short will make the fuse blow. Get back there, check your wires and find the short.

Alamo_City_210
02-04-2014, 03:09 PM
Power comes in from Green wire, Pin 21
FSM: EL pg 74
I was having the same problems a few days ago and tore through my whole harness behind the dash. A few wires (21 and 13) were spliced from PO. Why? Who knows but my gauges work now.

Alan_405
02-04-2014, 04:48 PM
Damn....This is going to suck hardcore. Wiring is my nemesis lol. I had to redo my harness when I swapped in the s14 sr as well. Never had any issues and it's been running amazing for the past 9 months

Alamo_City_210
02-04-2014, 04:51 PM
Its pretty straight forward. One step at a time. Your DMM is your friend.

Sent from my Nexus 5 using Tapatalk