babyjesus
06-08-2013, 01:24 PM
So i'm getting ready to do the manual trans swap on my s14. I'm using and s13 trans and plan on drilling the bell housing to fit the s14 CAS..my only problem is being able to drill the hole in the exact spot. I like to think i'm pretty good at search but have found no success on the subject. I've seen people make templates but non supply measurements. If one of you has a s14 trans lying around would you help a fellow zilvian out my posting the measurements of the cas holes?
the stuff i've found looks like this:
http://i223.photobucket.com/albums/dd249/icemhan21/stencil.jpg
http://i113.photobucket.com/albums/n235/motoman399/S14%20tranny/DSCN0957.jpg
any help would be appreciated...I understand that the holes don't need to be super spot on, so even if someone provided a ball park would help me out.
the stuff i've found looks like this:
http://i223.photobucket.com/albums/dd249/icemhan21/stencil.jpg
http://i113.photobucket.com/albums/n235/motoman399/S14%20tranny/DSCN0957.jpg
any help would be appreciated...I understand that the holes don't need to be super spot on, so even if someone provided a ball park would help me out.