LuckyX2
05-26-2013, 01:10 PM
I have a set of Geomaster 2 knuckles I'm installing on my S13. I know that the spindle on them is the larger S14 spindle so I ordered some "Contano" S14 5 lug hubs. Turns out they don't slide on and seem to require being pressed on.
Is this at all normal? What size should the spindle/bearing be? I'm getting about 1.340" OD on the spindle and about 1.337" ID on the bearing. As you can see, the spindle is a few thousandths larger and causing a problem.
Anyone else have any experience with Contano hubs and/or Geomasters? Just want to check before I sand down the spindle. Thanks.
Is this at all normal? What size should the spindle/bearing be? I'm getting about 1.340" OD on the spindle and about 1.337" ID on the bearing. As you can see, the spindle is a few thousandths larger and causing a problem.
Anyone else have any experience with Contano hubs and/or Geomasters? Just want to check before I sand down the spindle. Thanks.