PDA

View Full Version : After Geomaster rear knuckle install wheel hits RLCA under compression.


Wanabe
05-14-2013, 03:19 PM
Be gentle I don't ask for help much on here haha.

Ok guys, I installed a set of Driftworks Geomaster rear knuckles and now my wheels rub on the bottom of my RLCAs under compression due to the roll center correction lowering the lca almost two inches at the knuckle.

So far my options are either get aftermarket tubular LCA, or run a wheel spacer and get over fenders. Both of which are rather expensive for me right now.

If I went with 18's in the rear that could help too, but I really like my equips and I don't want to change wheels.

Pretty much what I'm asking here is if any of you have any experience with this. I want to know if there's a cheaper or faster option to solve my problem. Any help would be appreciated thanks.

PoorMans180SX
05-14-2013, 03:53 PM
Yeah I think you're pretty much stuck with getting a tubular LCA.