Need Help W/ This Asap!!!!!!!!!!!

[drftwerks]

so im installing a new set now i have a couple of problems

1. my pilot bushing is stuck i mean stuck stuck, how can i get it out, the tool from KRAGENS SUCKS ARSE.

2. teh pressure plate holes and the flywheel post teh part to line them up, arent fiitting on just right they are really really tight.

3. what is the easiest way to put that dam top bolt back on, i spent like 1.5 hrs on getting that dam thing off.

need this info ASAP
thanks

p.s not that i look at my clutch im pretty sure that was the problem, ill post pics asap.

Bryon

[andrave]

1. my brother and I just used a prybar and a hammer and tapped it off. spray some PB blaster on it and try that. If that doesn't work some torch heat would likely loosen it up for you.

2. I tapped mine on with a plastic faced hammer. Makes sure you have it on the right way and lined up. Are you using the alignment tool? you need to, if you aren't.

3. You know to lower the back end of the engine, right? hope so, that will give you more room to work. What I ended up using was a ratchet with a handle that stuck out over the bell housing, and then I used a closed ended wrench placed over the ratchet handle so that I could still reach it and move it. It is a bitch though, just get creative.