PDA

View Full Version : 95 240sx wont crank


Ninjataco
03-18-2013, 07:31 PM
i got my 240 back in November and now it wont start or crank
i replaced the ignition switch, clutch relay, clutch switch and have my starter checked, brand new battery too.i checked all the fuses and there good.
i also got the ignition switch and turned the t while the clutch was depressed and nothing.

when it was running it would shudder from a few crappy sensors that i replaced.
Now i'm just stumped :/ any help ?

No 240.. No id
03-18-2013, 08:06 PM
The starter has three wires. Skinny wire for the ignition 12 volts signal. The other two thick wires, One for the ground and the other one for the 12 volts.

The (skinny wire) the one that goes to the ignition should have a connect by the starter, Disconnect it and jump a wire from the battery all the way to it. See if it cranks, if it Crank, then that wire its not getting power from the ignition. Good luck

* Remember to disconnect that connector should be next to the starter!!!

Ninjataco
03-18-2013, 08:13 PM
I jump that connector to the pos or the negative?

No 240.. No id
03-18-2013, 08:17 PM
That connector need 12v to start the car. So to the positive.

Ninjataco
03-21-2013, 08:26 PM
ok i did it and it cranked so could it be the relays in the drivers kick panel?

* it starts noe but shakes and dies