ASD Hydro w/dual calipers...

[J0nJ0n]

Been searching and curious if anyone out here has any info on the required fittings and lengths for running a ASD hydro to a separate Z32 rear caliper setup. Thanks!

[TTnickdizzle]

http://zilvia.net/f/motorsports-skilled-driving/429165-show-me-your-hydro-ebrake-set-up-_.html

http://zilvia.net/f/brakes/402922-s-chassis-dual-caliper-kit-new.html

Forgot the fitting sizes but on my Z32 i used 3x 48" -3an lines with a -3an T. iirc the fittings were like 1/8npt or something

[ch1873857]

you need a -3 adapter fitting for the master on the hydro (dont know the thread pitch of ASD of hand i think 1/8npt like nick said.

90* to straight -3 prefab ss brake hose long enough to get back to the diff. 60 ish inch?
-3 tee fitting
(2) straight to straight -3 prefab brake hose 30 ish inches long
(2) m10x1.0 to -3 adapter fittings for brake calipers.

all can be found on summitracing for cheap. i spent like 100 bucks for all my brake lines in the rear. switched my service brake over to ss as well.

make sure you take extra precaution to secure the brake hoses out of the way of ANY moving parts. learn from my mistake

was coming into to a hairpin at summit point at 70ish mph for early entry. once i locked the rears the hose busted. why? unbeknownst to me the hose was rubbing the axel for quite some time and had been damaged when i destroyed a cv joint on that side's axel.