PDA

View Full Version : CA SOLD - Build Your Own AR15 Pistol/Rifle

counter_motion
03-13-2013, 05:52 PM
SOLD


I know this isnt car related, but there isnt an "Other" section, so just wanted to see if there's anyone else looking into getting into guns as well.

For those of you who may want to exercise your 2nd Amendment Right, build your own AR15.

NOTE -This is not a firearm, in its current state it is considered a piece of metal by the ATF. For it to be considered
a firearm, the purchaser will need to have the fire control group pocket (the place where the trigger goes) milled out.

If you are local to So.Cal I can direct you where to go to get the fire control group milled out to complete it.

-Oversized Integrated Trigger Guard

-No roll pin required for bolt catch as a pin and a set screw are included with each lower.

-Rear takedown pin detent hole is threaded for a 5/40 set screw to capture the spring


$250/pc - 0 -available (Post "I'll Take It" followed by PM)


FTF in Downtown LA- Pershing Square (M-F Noon)
Artesia/Cerritos (M-F After 6pm, Sat-Sun-Open)

Paypal accepted as "Gift"

Buyer pays shipping, can be shipped on day of purchase if before 5pm PST (M-F).

Example of a finished product:
http://i.imgur.com/T2ILq.jpg

http://i4.photobucket.com/albums/y107/ReX_n/Guns/IMAG0114_zps98d8d26a.jpg

http://i4.photobucket.com/albums/y107/ReX_n/Guns/IMAG0113_zps42aef3d9.jpg

http://i4.photobucket.com/albums/y107/ReX_n/Guns/IMAG0108_zps8b15bba7.jpg

http://i4.photobucket.com/albums/y107/ReX_n/Guns/IMAG0110_zps848e717a.jpg

http://i4.photobucket.com/albums/y107/ReX_n/Guns/IMAG0112_zpsebd1a25b.jpg
idahotuner
03-13-2013, 06:07 PM
very nice milling and machining
OrangeVirus1
03-13-2013, 06:13 PM
So does it actually fire 5.56mm?
counter_motion
03-13-2013, 06:27 PM
It could fire 5.56/.223 or 9mm, it just depends on the upper receiver that you mate to it.

So does it actually fire 5.56mm?
OrangeVirus1
03-13-2013, 06:31 PM
If you could make one for an AK-47, I'd buy
lancesr201
03-13-2013, 06:53 PM
ill take it. pm sent
lewisfk
03-13-2013, 06:56 PM
Are you working with a shop in San Marcos? I was told by a couple of MILITARY guys that a company wil help u mill the pieces needed to build an AR and it would be sold as a kit gun. I was looking at that option, so i can build a custom AR10!
rob_240
03-13-2013, 07:34 PM
Jesus 250 for a stripped non with no trigger
slamn240
03-14-2013, 04:46 AM
do you have any more???? im very interested