Slightly Used WPC Treated Tomei Cams for S13 SR20DET

[2_Liter_Turbo]

Well, it turns out that I have the wrong cams (I originally ordered cams for solid lifters, and I got hydraulic lifter cams instead). Never thought to check part numbers until now... so now I have to sell these to get the ones I need. These are low mileage Tomei 260 duration (12mm lift) procams. They are for Hydraulic lifters only! They were used for about 1500 miles, then WPC treated, then used a whopping 6-8 miles since the treatment. There is a wear mark on the #4 exhaust lobe, but it's very small, and on the edge of the lobe. I'll post a picture of what they look like now this weekend, but the pics below are only 8 miles prior (right after I got them back from WPC). So there is little difference. Just the bearing surfaces are a little shiny now since it was ran.



Cams after they came back from WPC treatment (Costs $160 + shipping two ways)
http://img.photobucket.com/albums/v689/93s13/My%20S13/SRBuild3/10-15-12_SRBuild3_01.jpg

Close up after WPC
http://img.photobucket.com/albums/v689/93s13/My%20S13/SRBuild3/10-15-12_SRBuild3_02.jpg


#4 Exhaust Lobe wear mark on lobe top only (about .001-.002" measured with calipers)
http://img.photobucket.com/albums/v689/93s13/My%20S13/SRBuild3/02-21-13_CamIssue-02.jpg

$360 shipped in the lower 48 states.

[2_Liter_Turbo]

Here are current pictures (8 miles after being installed). The "lines" you see are not damage wear marks, they are where the WPC treatment finish hasn't been rubbed off yet. That's how little they were ran since getting treated.

http://img.photobucket.com/albums/v689/93s13/Forum/ForSale/03-16-13_Tomei260Cams_1.jpg

http://img.photobucket.com/albums/v689/93s13/Forum/ForSale/03-16-13_Tomei260Cams_2.jpg

[2_Liter_Turbo]

SOLD!!! Admins; can you please lock this. Thanks!