Johny5
02-26-2013, 11:53 AM
Stack 8100 w/ stack pro-control fuel level gauge and kill switch. made to bolt on to 240sx dash housed in plexi and wrapped in a nice black suede. includes 2 pressure and 2 temp sensors that are brand new, they just aren't stack sensors (exact same range) asking $1200 for everything
http://img.photobucket.com/albums/v338/kidnrg/old%20one%20was%20full/SDC11037_zpsb0150a36.jpg
http://img.photobucket.com/albums/v338/kidnrg/old%20one%20was%20full/SDC11049_zpsd04d154d.jpg
Custom sway bars
5 way adjustable at each corner, solid endlinks at each corner each with a high misalignment male end offering 55 degrees of angle.
http://www.stewartleask.com/wp-content/uploads/2012/07/SDC10886.jpg
they're based off of tanabe sway bars with 1/2" chromoly solid ends welded on. I replaced all the D-bushings when I installed them and will include stack spacers for the rear D-bushings in case the rear sway doesn't clear your exhaust (didn't clear my 4" or aftermarket driveshaft so I made these). I'm asking $800 for the setup F/R
Custom FLCA w/ 3/4" Aurora high misalignment bearing for balljoint and Aurora inner rod ends for length adjustment. Arms have been cupped for tie rod clearance and gusseted underneath for strength $400
Battle Version tension arms, bearings still in great condition $120
contact me at [email protected] or through PM here, fast response will be given. many many many more parts to come, thanks for looking!
http://img.photobucket.com/albums/v338/kidnrg/old%20one%20was%20full/SDC11037_zpsb0150a36.jpg
http://img.photobucket.com/albums/v338/kidnrg/old%20one%20was%20full/SDC11049_zpsd04d154d.jpg
Custom sway bars
5 way adjustable at each corner, solid endlinks at each corner each with a high misalignment male end offering 55 degrees of angle.
http://www.stewartleask.com/wp-content/uploads/2012/07/SDC10886.jpg
they're based off of tanabe sway bars with 1/2" chromoly solid ends welded on. I replaced all the D-bushings when I installed them and will include stack spacers for the rear D-bushings in case the rear sway doesn't clear your exhaust (didn't clear my 4" or aftermarket driveshaft so I made these). I'm asking $800 for the setup F/R
Custom FLCA w/ 3/4" Aurora high misalignment bearing for balljoint and Aurora inner rod ends for length adjustment. Arms have been cupped for tie rod clearance and gusseted underneath for strength $400
Battle Version tension arms, bearings still in great condition $120
contact me at [email protected] or through PM here, fast response will be given. many many many more parts to come, thanks for looking!