di-devol
02-15-2013, 04:29 PM
Garrett To4E T3 50 trim .64 a/r
Has in and out shaft play, didn't notice it till it came off, was rippin just fine haha. Journal bearing, cheap to rebuild.
$200
http://sphotos-a.xx.fbcdn.net/hphotos-ash4/c0.0.403.403/p403x403/293222_111563912345989_2051963538_n.jpg
http://sphotos-b.xx.fbcdn.net/hphotos-ash3/c0.0.403.403/p403x403/167465_111563919012655_3394428_n.jpg
Jim Wolf ECU $225
S13 SR20det redtop
was tuned for
9:1 comp,Sard 850cc's,o2 feedback, z32 maf
Unless your setup is the same, you will need a re-tune. I think it's $100
http://sphotos-a.xx.fbcdn.net/hphotos-prn1/553055_126160394219674_1074615881_n.jpg
Z32 maf with pigtail had a crack fixed before sensor, $60 shipped
Fidanza light weight FW for a 7m with R154/ never used, only mounted $200 shipped.
Has in and out shaft play, didn't notice it till it came off, was rippin just fine haha. Journal bearing, cheap to rebuild.
$200
http://sphotos-a.xx.fbcdn.net/hphotos-ash4/c0.0.403.403/p403x403/293222_111563912345989_2051963538_n.jpg
http://sphotos-b.xx.fbcdn.net/hphotos-ash3/c0.0.403.403/p403x403/167465_111563919012655_3394428_n.jpg
Jim Wolf ECU $225
S13 SR20det redtop
was tuned for
9:1 comp,Sard 850cc's,o2 feedback, z32 maf
Unless your setup is the same, you will need a re-tune. I think it's $100
http://sphotos-a.xx.fbcdn.net/hphotos-prn1/553055_126160394219674_1074615881_n.jpg
Z32 maf with pigtail had a crack fixed before sensor, $60 shipped
Fidanza light weight FW for a 7m with R154/ never used, only mounted $200 shipped.