SLYDEWAYS 96
02-05-2013, 07:21 PM
I have a 96 240sx ka24, I recently had a code for the knock sensor which I fixed and cleared the code with my diagnostic reader. After driving the car around the CEL came back on. I ran the code with my reader and no codes came up. I cleared it and after some more driving it still comes back on. Any ideas what could be the problem? If it helps, the previous owner swapped the cluster and the odometer & mileage reading does not work.
I also have another problem with my gas needle. Saturday I had a 1/4 tank of gas. It took 12.5 gallons to fill up. The needle was over the Full mark and I drove around a good 60 miles with it. Yesterday the needle was right on the Full mark. Today the needle reads about half tank after driving another 15 miles. Think its a cluster problem or my floater is bad?
I also have another problem with my gas needle. Saturday I had a 1/4 tank of gas. It took 12.5 gallons to fill up. The needle was over the Full mark and I drove around a good 60 miles with it. Yesterday the needle was right on the Full mark. Today the needle reads about half tank after driving another 15 miles. Think its a cluster problem or my floater is bad?