PDA

View Full Version : WI Greddy Engine Oil Block Adapter - SR20 - $90 Shipped


blackej7
01-01-2013, 01:45 PM
Sold....


I went a different route with my oil cooler setup so I have this available. It the one with the thermostat. Both port plugs have been drilled and tapped for sending units, 1/8PT 18mm. I used the factory sending unit for the oil light in the dash along with an aftermarket sensor (Greddy). This was installed on my SR for about 2000 miles. It is very clean and 100% functional, I simply wanted to go with a different setup.

http://farm9.staticflickr.com/8503/8335066872_abcbd89fab_b.jpg

http://farm9.staticflickr.com/8081/8335067040_9efb48f43a_b.jpg

http://farm9.staticflickr.com/8080/8335067110_7c228593df_b.jpg

If someone needs it, for $10 I can add an extra plug if you plan to only use one sending unit:

http://farm9.staticflickr.com/8502/8335067178_978429a0c8_b.jpg

It looks like FRSport has these for around $130. I am asking $90 shipped, or $100 with the additional plug. Please PM me on here. Thanks!

blackej7
01-13-2013, 10:07 AM
Still available....

s13mikesr20
01-13-2013, 10:42 AM
I want looking for any parts to put dent into price

blackej7
01-17-2013, 01:49 PM
Not sure what your asking.... Still available though.

s13mikesr20
01-17-2013, 06:44 PM
Trade and cash are you looking for any parts sorry....

flatout
01-17-2013, 06:53 PM
Did you have any issues with clearance with the motor mount? I was thinking about picking one of these up and might be interested

Sent from my Galaxy Nexus using Tapatalk 2

blackej7
01-17-2013, 06:57 PM
Sure, l am looking for:

Extended wheel studs
Open ended lug nuts
S13 rear wheel bearings
Side mount seat rails/brackets

Let me know

blackej7
01-17-2013, 07:03 PM
Did you have any issues with clearance with the motor mount? I was thinking about picking one of these up and might be interested

Sent from my Galaxy Nexus using Tapatalk 2

Its close, but there are no issues. I ran two -10 straight fittings from the bottom ports, but you can do whatever works for your setup.

http://farm5.staticflickr.com/4035/4452330399_d3c8c5c8f9_o.jpg

blackej7
01-21-2013, 09:16 AM
This really does make adding an oil cooler/thermostat very clean and simple.

blackej7
02-02-2013, 03:17 PM
Still available..

richmond82
06-25-2013, 09:00 AM
is this part still available ?

richmond82
06-25-2013, 09:04 AM
shoot sorry. I must of skimmed over the part where you said it was sold...