trujdm300zx
12-30-2012, 07:14 AM
1991 Nissan 240sx Shell
No rust on undercarriage, only one spot of rust on the body
66,311 miles on the car
Thats right, clean low mile drift car
Good-
Ksport Coilovers
Modified steering knuckles
Modified front subframe/steering rack for more steering angle
All new Bushings throughout entire chassis
Aluminum subframe collars
17" Enkei Wheels in the front
15" Factory Se wheels in the rear
Hydro E-Brake/ made with wilwood master cylinder
Power steering cooler mounted
Battery relocation power wire routed
Kill switch installed
Push button start wired in
Z32 fuel filter
Extra Dash
Extra Axle
Stock drivers seat
Pig nose front bumper
Aftermarket racing seat
World War II oil pressure gauge mounted on the hood (may not be a good thing)
Includes 2 sets of headlight buckets
Includes 2 sets of headlight covers
Includes 2 sets of headlight brackets
One set of glass headlight lenses
One set of projector headlight lenses
Bad-
Body could use some attention, passanger fender dented up, passanger rear quarter
panel has a good amount of body filler, one of the rocker panels has a dent in it, and
there is a dent at the lr corner of the car
Dash/ Front chassis harness was "thinned" by the previous owner
(custom fuse box inside the car and the wiring is a bit messy)
Ignition, turn signals, and hvac control head previously removed
Stripped interior( Interior panels include dash, headliner, seat, and a set of door pads)
Began fixing the major issues from the previous owner
Example: Rear coilover lower mounts were seized, collars were seized and they were adjusted inches
different in height, one coilover's spring preload was backed way off to compensate. I had free'd
up all the collars (still spin freely) but i had to cut off one lower mount to even them out. Mount was prfessionally rewelded
Tada'
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0724121600_zpse17997c6.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0724121559_zps89378e2e.jpg
This is a PROJECT CAR, this car is not perfect and I am not representing it to be.
This car has been previously set up to drift
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0528122050_zpsc2b16dd9.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0528122051_zps8f7656b3.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/1016121801_zps23620cb1.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/CAM00192_zpsabd59310.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/CAM00202_zpsc08f9d15.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/CAM00203_zpsddc40d11.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/CAM00191_zps75d736e7.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/downsized_0808121725.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0808121721-1_zps3e4cd752.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0808121731a.jpg
Asking $800obo
Pm me with offers, or questions I'm more than happy to give more details about the car
Call or txt Ben at 810-768-8131
Preferably txt
No rust on undercarriage, only one spot of rust on the body
66,311 miles on the car
Thats right, clean low mile drift car
Good-
Ksport Coilovers
Modified steering knuckles
Modified front subframe/steering rack for more steering angle
All new Bushings throughout entire chassis
Aluminum subframe collars
17" Enkei Wheels in the front
15" Factory Se wheels in the rear
Hydro E-Brake/ made with wilwood master cylinder
Power steering cooler mounted
Battery relocation power wire routed
Kill switch installed
Push button start wired in
Z32 fuel filter
Extra Dash
Extra Axle
Stock drivers seat
Pig nose front bumper
Aftermarket racing seat
World War II oil pressure gauge mounted on the hood (may not be a good thing)
Includes 2 sets of headlight buckets
Includes 2 sets of headlight covers
Includes 2 sets of headlight brackets
One set of glass headlight lenses
One set of projector headlight lenses
Bad-
Body could use some attention, passanger fender dented up, passanger rear quarter
panel has a good amount of body filler, one of the rocker panels has a dent in it, and
there is a dent at the lr corner of the car
Dash/ Front chassis harness was "thinned" by the previous owner
(custom fuse box inside the car and the wiring is a bit messy)
Ignition, turn signals, and hvac control head previously removed
Stripped interior( Interior panels include dash, headliner, seat, and a set of door pads)
Began fixing the major issues from the previous owner
Example: Rear coilover lower mounts were seized, collars were seized and they were adjusted inches
different in height, one coilover's spring preload was backed way off to compensate. I had free'd
up all the collars (still spin freely) but i had to cut off one lower mount to even them out. Mount was prfessionally rewelded
Tada'
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0724121600_zpse17997c6.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0724121559_zps89378e2e.jpg
This is a PROJECT CAR, this car is not perfect and I am not representing it to be.
This car has been previously set up to drift
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0528122050_zpsc2b16dd9.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0528122051_zps8f7656b3.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/1016121801_zps23620cb1.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/CAM00192_zpsabd59310.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/CAM00202_zpsc08f9d15.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/CAM00203_zpsddc40d11.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/CAM00191_zps75d736e7.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/downsized_0808121725.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0808121721-1_zps3e4cd752.jpg
http://i654.photobucket.com/albums/uu269/TRUJDM300zx/0808121731a.jpg
Asking $800obo
Pm me with offers, or questions I'm more than happy to give more details about the car
Call or txt Ben at 810-768-8131
Preferably txt