apexi n1 duals

[uknoenicka]

whats the average installation time for n1 duals on a 92 coupe? anything tricky?

[epoxy_nc]

i doesnt matter what exhaust it is... its just hanging stuff from the frame and bolting it to the turbo extension.

everyone works at their own pace.

i'm not sure about if yuo have to cut the bumper or not.. because they are duals. but puting an exhaust on isnt bad at all.. dont be scared :tweak:

[Tubed4evr]

haha it depends . . . Are you on the East coast? If so then be ready for some rusty fasteners. We ran into all sorts of problems on this typically easy install. I had stud a break on the Cat and had to drill it out and replace it with a bolt. I would suggest soaking the nuts in liquid wrench for a couple hours before hand. It might save you alot of hassle.

If all goes well you can do it in about an hour or 2 after its all said and done.

Ryan

[mobilesuit818]

I did my girlie's in like 30 minutes.
I would suggest getting extra gaskets for after the cat, cause the piping does not line up all the way.

good luck

[duey]

i did mine in about an hour, even with frozen bolts. Only thing is make sure u assemble the exhaust BEFORE you bolt it to the car, there are 5 bolts that connect the axle back and the b pipe, just make sure those 5 bolts are tightened down first cuz they're a pain to tighten once the b pipe is on the car.