drift freaq
12-17-2012, 11:33 AM
Ok Folks its Christmas Special Time on my High Quality Polyurethane Engine and trans mounts.
Yup 80 Durometer poured Polyurethane Engine and transmission mounts. Designed to position your engine at its optimum position in your engine bay.
Low enough to clear strut braces and give you good center of center of gravity but too low as to drop your oil pan down below the cross member.
These mounts are designed for optimum strength, 80 Durometer! Without causing excessive vibrations. The studs are not connected to each other.
These have been excessively track tested and this is the latest version.
The trans mount is the only trans mount on the market with an exhaust hanger and it is designed to support the trans as the factory originally intended. Rather than just being a lump of urethane with studs.
It will improve your shifting feel as your trans will no longer wiggle around . That means no more miss shifts in tight situations.
Now given all this I do have a one month manufacturers warranty against possible workmanship defects.
You must use a heat shield on the exhaust side of engine!
I do not warranty them for off road use. There are a number of reasons for this and quite honestly most all manufacturers who make off road i.e. race products do not warranty them at all.
With that said there are a lot of my mounts being used in a lot of different motorsports classes and they are a Performance product designed to improve your edge.
Will all of this the special pricing is $115 for the engine mounts plus $16 for shipping.
The special pricing on the trans mount is $115 plus shipping of $16 as well.
Buy them as a set and get another $5 off for a total of $225 plus $19 for shipping.
http://i705.photobucket.com/albums/ww52/driftfreaq/IMG_0365_zps057dabdb.jpg
http://i705.photobucket.com/albums/ww52/driftfreaq/IMG_0364_zps1923722b.jpg
Yup 80 Durometer poured Polyurethane Engine and transmission mounts. Designed to position your engine at its optimum position in your engine bay.
Low enough to clear strut braces and give you good center of center of gravity but too low as to drop your oil pan down below the cross member.
These mounts are designed for optimum strength, 80 Durometer! Without causing excessive vibrations. The studs are not connected to each other.
These have been excessively track tested and this is the latest version.
The trans mount is the only trans mount on the market with an exhaust hanger and it is designed to support the trans as the factory originally intended. Rather than just being a lump of urethane with studs.
It will improve your shifting feel as your trans will no longer wiggle around . That means no more miss shifts in tight situations.
Now given all this I do have a one month manufacturers warranty against possible workmanship defects.
You must use a heat shield on the exhaust side of engine!
I do not warranty them for off road use. There are a number of reasons for this and quite honestly most all manufacturers who make off road i.e. race products do not warranty them at all.
With that said there are a lot of my mounts being used in a lot of different motorsports classes and they are a Performance product designed to improve your edge.
Will all of this the special pricing is $115 for the engine mounts plus $16 for shipping.
The special pricing on the trans mount is $115 plus shipping of $16 as well.
Buy them as a set and get another $5 off for a total of $225 plus $19 for shipping.
http://i705.photobucket.com/albums/ww52/driftfreaq/IMG_0365_zps057dabdb.jpg
http://i705.photobucket.com/albums/ww52/driftfreaq/IMG_0364_zps1923722b.jpg