240jake
11-29-2012, 05:07 PM
So i purchased an enthalpy tuned sr20det e5 ecu, i sent it to him and he verified the tune that was on it for me, all stock except z32 maf.
Now when i try to run it, i wire in my z32 maf, and start the car but it runs way rich 10+ and it doesn't see the maf signal it seems, as unplugging the mafs makes no difference.
The red led light on the ecu does not turn off either, it just stays illuminated even after the car is running.
At first i assumed i got a bad maf, so i replaced it with a working one, same thing.
I also removed the eeprom and reseated it on the enthalpy daughterboard.
Using the ecu reset screw does nothing, light is still red.
Did i get a bad ecu?
any suggestions would be highly appreciated!
Now when i try to run it, i wire in my z32 maf, and start the car but it runs way rich 10+ and it doesn't see the maf signal it seems, as unplugging the mafs makes no difference.
The red led light on the ecu does not turn off either, it just stays illuminated even after the car is running.
At first i assumed i got a bad maf, so i replaced it with a working one, same thing.
I also removed the eeprom and reseated it on the enthalpy daughterboard.
Using the ecu reset screw does nothing, light is still red.
Did i get a bad ecu?
any suggestions would be highly appreciated!