PDA

View Full Version : FS: z32 TT Front Calipers & Rotors 30mm alum.


mmdb
03-17-2004, 09:39 PM
I purchased this set (300zx tt) and I decided I'll hold off on it till later. I ordered from texas so it should be here during this week or early next. I'd recommend rebuilding the calipers and resurfacing the rotor. I'm in so cali and would prefer pick up. Asking 250 obo.

Email: [email protected]
aim: imsexrdenu

gosuS14
03-17-2004, 10:25 PM
i am in so cal also.. interested in the calipers for sure but don't need the rotors... wiling to cut a good deal to a local pickup? call me if you can 714 863 8382

mmdb
03-18-2004, 12:06 AM
I'd like to get rid of both at the same time since it wouldn't do me any good for the rotors to sit around.

dct223
03-18-2004, 03:44 PM
damn.. thats a pretty good deal... Just bought lots of stuff so no money... free bump though =D

nlzmo400r
04-27-2004, 09:39 PM
what exactly occurs in a 'rebuild'? is this very expensive, also im assuming these wont fit under my SE rims? or can i get longer wheel studs or spacers or something?

INeedNewTires
04-28-2004, 12:11 AM
complete rebuild: complete disassembly and inspection of some part. After measurements are taken any and all parts that are out of "spec" are replaced with new parts. After that everything is cleaned before full reassembly in the proper order with new grease/new fittings where needed.

as for your question, nizmo... you OBviously have to be alot more specific when you ask a question like that, and not only are you probably going to get a lil burnt from asking such a vague question and expecting an answer, you are also gonna get hit with the oh so common "USE THE SEARCH BUTTON MORON" reply. which would be my answer to you as well as this topic has been covered hundreds of times in hundreds of posts across hundreds of boards.


anyway, got any pics? send em to [email protected] and try to include pics of the seals around the pistons. thanks

mmdb
04-28-2004, 12:40 AM
sorry they're sold. :(

nlzmo400r
04-28-2004, 07:40 PM
complete rebuild: complete disassembly and inspection of some part. After measurements are taken any and all parts that are out of "spec" are replaced with new parts. After that everything is cleaned before full reassembly in the proper order with new grease/new fittings where needed.

as for your question, nizmo... you OBviously have to be alot more specific when you ask a question like that, and not only are you probably going to get a lil burnt from asking such a vague question and expecting an answer, you are also gonna get hit with the oh so common "USE THE SEARCH BUTTON MORON" reply. which would be my answer to you as well as this topic has been covered hundreds of times in hundreds of posts across hundreds of boards.


anyway, got any pics? send em to [email protected] and try to include pics of the seals around the pistons. thanks
oh, didnt know it had been asked, sorry, my fault for not using the search button. Sorry for takin up your guys time, thanks for hte help anyway