WTB: S14 Rear subframe stud

[irax]

I need the stud for the rear subframe. Specifically the drivers side front.

[ShadowDrifter]

If they come out I have them here pm me

[JDS Performance]

They are welded in

[tnd240]

They are welded in

Unless they are different than the S13 Frames, they are pressed in from the factory - I just removed one myself, from my Hatch.

I do have one more replacement, but I want to get the other one in properly before I decide to offer up the other - I will take pics of my project, how it is pressed in, and the stud later this evening.

It is the same design as found with the studs used on Nissan Wheel Hubs - the perches have splines running up the side of them along the shaft of the stud, at the base - you will have to heat up the the perch of the stud and HAMMER it out. Since I did not have a Acetylene Torch, it took three small propane heaters and a good 15-20 minutes held in place around the base of the stud to generate enough heat to bang the original one out - two heaters did not work.