newslidz
09-19-2012, 06:59 PM
Hi. I had purchased a set \5 lug conversion hubs through frsport.com. recieved the box a little ruff but there hubs they can handle a little beating. I am trying to install them, but having issues with them. Now I work on cars for a living and this is not my first set of hubs ive installed. something isnt right im not gonna force them. I am not sure if the bearings are to thick but your unable to tighten the spindle nut because of it. they seem to be butted together nicely.
I also read online on some of the forums that you guys had some batches with the rear C clip was to big so I tried using the oem one off the 4 lug hubs. it seemed to help but not enough. its close and Ill post some pics below so you can see. the washer that goes in the hub behind the nut is whats stopping them from turning but thats because there not seating correctly. you can see how the rotor is off just a little from center. and thats the diffrence down on the spindle that it needs to go back still.
ANY HELP OR KNOWLEDGE WOULD BE GREATLY APPRECIATED
I also read online on some of the forums that you guys had some batches with the rear C clip was to big so I tried using the oem one off the 4 lug hubs. it seemed to help but not enough. its close and Ill post some pics below so you can see. the washer that goes in the hub behind the nut is whats stopping them from turning but thats because there not seating correctly. you can see how the rotor is off just a little from center. and thats the diffrence down on the spindle that it needs to go back still.
ANY HELP OR KNOWLEDGE WOULD BE GREATLY APPRECIATED