waste_of_space
09-11-2012, 10:33 PM
Alright, have a set of black faced Defi BF link meter gauges (red in color, and they're metric)
New these 3 gauges would cost $690 without shipping from phase2motortrend.
These gauges are used, and have some scratches on the gauge face (most notably on the boost gauge itself).
I don't have the control unit for these gauges, it's just the 3 gauges (and sensors).
All sensors intact, EXCEPT one of the temp sensors is missing the plastic connector (the part that clips into the actual link controller) You could just push the wires onto the pins inside the link meter, or probably source that little two pin connector. Will take close up shots of all defects for seriously interested persons.
A brand new link controller is only $115 from phase2, so I'm sure you can find one used for cheaper.
I'll either sell these or end up running them and selling my apexi gauges, I just don't have the need for two sets of the exact same gauges lol.
Here's more info if you need it:
Oil temp: Defi 60mm Link BF Oil Temperature Gauge (http://www.phase2motortrend.com/238bfoiltemg.html)
Boost: Defi 60mm Link BF Boost Gauge (http://www.phase2motortrend.com/238bfboosgau.html)
Water temp: Defi 60mm Link BF Water Temperature Gauge (http://www.phase2motortrend.com/238bfwattemg.html)
http://i48.tinypic.com/11bi3xj.jpg
And the needed controller: Link Control Unit II (http://www.phase2motortrend.com/linconunii.html)
New these 3 gauges would cost $690 without shipping from phase2motortrend.
These gauges are used, and have some scratches on the gauge face (most notably on the boost gauge itself).
I don't have the control unit for these gauges, it's just the 3 gauges (and sensors).
All sensors intact, EXCEPT one of the temp sensors is missing the plastic connector (the part that clips into the actual link controller) You could just push the wires onto the pins inside the link meter, or probably source that little two pin connector. Will take close up shots of all defects for seriously interested persons.
A brand new link controller is only $115 from phase2, so I'm sure you can find one used for cheaper.
I'll either sell these or end up running them and selling my apexi gauges, I just don't have the need for two sets of the exact same gauges lol.
Here's more info if you need it:
Oil temp: Defi 60mm Link BF Oil Temperature Gauge (http://www.phase2motortrend.com/238bfoiltemg.html)
Boost: Defi 60mm Link BF Boost Gauge (http://www.phase2motortrend.com/238bfboosgau.html)
Water temp: Defi 60mm Link BF Water Temperature Gauge (http://www.phase2motortrend.com/238bfwattemg.html)
http://i48.tinypic.com/11bi3xj.jpg
And the needed controller: Link Control Unit II (http://www.phase2motortrend.com/linconunii.html)