Parting out S13 Clip

[focused]

I have a clip left from my swap i'm looking to part out.. If there's anything you need that may be there email me and ask. Notably I have the brake booster and master cylinder, along with all calipers, brackets, hubs, and control arms. I also have the sway bar, steering rack, dash, blower motors, all duct work, and a digital climate control that was working when i first got the clip.

http://www.ricksautomotiveservice.com/clipp.jpg

Also, i have these. two front Tein coilovers for s13, tein has told me that they are an older model, Type H1. Not sure about selling these, make your offer.

http://www.ricksautomotiveservice.com/coil.jpg

Oh yeah, i also have some brown silvia floor mats.. make your offer..

http://www.ricksautomotiveservice.com/fs/floormat01.jpg

[bruce240]

interested in control arms. will these fit usdm? i know the brakes are bigger than usdm so control arm might be diff too.

[focused]

interested in control arms. will these fit usdm? i know the brakes are bigger than usdm so control arm might be diff too.

I was under the impression the brakes were the same, the model of the car was actually a Silvia Q series (non-turbo).

[Gzero]

40 bucks for the front shocks they look pretty fubared

[mykem]

whats up, this is mykem from cii, can you snap a pic of the digi climate control? does it have any of the sensors or did those get chopped?

[khemix]

I want the brake booster and master cylinder. How much? I've got money in hand, but have a couple offers as of now. Thanks and just lemme know! [email protected]

Chris

[xxxsleeperxxx]

ill take digital climate control if it has all of the wiring/sensors with it please email me at [email protected]

[focused]

i'll reply to the emails ive received tonight, and to answer a the climate control questions, I do have the full interior harness, so i do have the plugs to the digital climate control. When i get a chance i'll find the plugs and trace them back a ways before i make a cut.

I'll get back to you all on prices later tonight.

thanks.

[focused]

40 bucks for the front shocks they look pretty fubared


i believe that the camber plates on these are worth more then $40 alone.

[mistaanime]

hahah...shiet..i'd buy them for 50 then! ..actaully PM me how much you want outta it and i'd probably get them off you.... :bow:

[DRFT]

ill give you 100 for the front teins

[mykem]

actually..do you have the manual transmission crossmember and mount? i'm not sure if you need these for your swap or not, but if you have them and can sell..i'm in need of one

AND did the guy who bought the front end conversion take the front bumper support? its still on the clip in the picture..i'd be interested in that as well

[focused]

no the guy didnt get the support, so it's still there. I brought the climate control home and will take a picture for you as well. And about the crossmember and mount, I left the SR one attached and just bolted up when i did the swap, I do have one still on the KA trans, but i'm not sure if i want to pull this off or not.

[fogleroller]

how much do you think it would be to ship the radiator support? Is it straight?

[chineseb0i]

i'm interested in the front bumper support bolts (there should be 4 of them) i figured if you're scrapping them then you won't need those 4 bolts. If so, i will gladly send you a few dollars plus shipping.

Solomon

[andrave]

I will pay 5 shipped for a TC bushing bolt, I have to cut mine off my car (seized) so I need a replacement.
[email protected]

[daisosasen01]

I have a clip left from my swap i'm looking to part out.. If there's anything you need that may be there email me and ask. Notably I have the brake booster and master cylinder, along with all calipers, brackets, hubs, and control arms. I also have the sway bar, steering rack, dash, blower motors, all duct work, and a digital climate control that was working when i first got the clip.

http://www.ricksautomotiveservice.com/clipp.jpg

Also, i have these. two front Tein coilovers for s13, tein has told me that they are an older model, Type H1. Not sure about selling these, make your offer.

http://www.ricksautomotiveservice.com/coil.jpg

Oh yeah, i also have some brown silvia floor mats.. make your offer..

http://www.ricksautomotiveservice.com/fs/floormat01.jpg
Interested on the front control arms. And also the A/C COndensor radiator thing with the hose.
Let me know how much shipped to 92114
thanks
Koji

[spykes]

i need the radiator support and i need the bumper support
drop me a price and i'll see if i can get it within my buget

[darksyde]

still got the digital climate control? or did the other guys get to it already? please let me now....PM me i tend to forget where i leave replys..thanks

[shawn_161]

do you have the front brake set (rotors,calipers)

[bruce240]

send me an email at [email protected] id liek to get more info on the control arms.

[spykes]

i dont think he is selling nothing no more cause he hasnt responded to serveral PMs

[focused]

Sorry for the delay everyone. I've replied to PM's. Just been busy lately.

[focused]

Front Brake setup is just as pictured (on the page below) they come with the spindle, hub, rotor, caliper, pads, and the rubber lines if you want them. I'll let these go for $80+shipping.

Front Control Arms: $35+shipping

Bumper Support Bolts: Spykes currently has dibs on the radiator and bumper support if he wants it, if he doesnt want those bolts then by all means they're yours.


http://www.ricksautomotiveservice.com/clip.htm
*Pictures of the clip intact.

[focused]

http://www.ricksautomotiveservice.com/fs/brake02.jpg

http://www.ricksautomotiveservice.com/fs/brake01.jpg

[jkjunior]

i need one power steering line of that rack

[edpogi]

do you still have the front tein's?

[focused]

yes, i still have the front teins

[WILDACEX187]

wat about the digital climate control? im looking to get the actuator, but i'll take the whole assembly. how much?

[ryan hagen]

how much for the teins?

[crxcess]

Can I get the clutch pedal? is it still on there? let me know.
[email protected]

[focused]

Can I get the clutch pedal? is it still on there? let me know.
[email protected]

Still have the pedal, and as for the climate control you'll have to find me pictures of what all you need, so i can get it together, and then come up with a price.

[focused]

I got pretty much everything that has been requested off of the clip. Minus the bumper and radiator support. the bumper support has cuts on each end and is bent a little on the right side. If anyone really wants these they are more then welcome to come get them off and take them home for cheap unless someone really wants to pay for my time to take them off and arrange shipping. I'll get pictures sometime soon of all the stuff i took off, and for those of you interested in the digital climate control, you'll have to help me out with what sensors and such i would need to take off and include with it. Thanks.

[crxcess]

i need just the pedal assy off the car, it unbolts from the master cylinder and 1 bolt under the dash. let me know how much?

[focused]

i need just the pedal assy off the car, it unbolts from the master cylinder and 1 bolt under the dash. let me know how much?

Yeah, I got it off yesterday. How does $25+shipping sound?

[ryan hagen]

how much for the teins? still wanting to know, im pretty interested...my hks need some work so i m looking for some front onlys to use till i get em fixxed

[focused]

i'm looking for $300+shipping right now

[focused]

Here are the pictures

[focused]

Here are the pictures

a few more

[crxcess]

$25 plus shipping sounds good! email me and we can make arrangments.
[email protected]

[focused]

the list (all prices without shipping):

clutch pedal - sale pending
brake pedal - $20
teins: fronts - $300
brakes - $75 (as pictured)
control arms - $35
tension rods - $20
digital climate control - around $70 with all sensors and such
washer fluid resevoir - $10
master cylinder with booster - $50
clutch master cylinder - $35

Interested in anything?
Email me at [email protected]

Prices listed are what i'm looking for, offers are welcome but dont lowball.

[jOeHaCk98]

Is the radiator support a bolt on piece or a weld on piece, thanks.

[90240sxkid]

would you be interested in selling just the calipers? if so are they in good condition and how much? also, they will fit onto a 90' 240sx hatchback right?

[focused]

Is the radiator support a bolt on piece or a weld on piece, thanks.


to get it off i'd have to torch it, it's spot welded to the car.

the calipers should fit any s13... I'd do $50+shipping for both calipers.