z32 upgrade with rusted lines

[d_nice]

hey guy. hope someone can help me out on my z32 upgrade. i have upgraded my s13 to z32 front and rear and everything is bolted up. now i am trying to change the bmc and the the lines looks rusted in their.. i wd40 and spray with blaster to try to take them out. got one out but the other two wont come out.. i used a line wrench on it but still not working. might have strip one out but still life left on it.. if i keep using the line wrench i am going to strip . my last option is to use the old bmc which is a 7/8 and dont want to use it but i dont see any other way. anyone had this issue that can assist me.

[d_nice]

any help guys

[fliprayzin240sx]

If you already started rounding it off with a line wrench...vice grip.

[andruha]

yup, just make sure teeth are still good on them, clamp it as hard as you can so the teeth would sink into the metal, and then use a hammer or i sometimes use a pipe from my hydro. lift

[HPKMotorsports3]

put a torch to it and it should release... i just did my swap last weekend and i had to replace both my rear calipers =/ SWAP THE BMC! IT FEELS LIKE SHIT AND IF YOU DONT

[d_nice]

ok thanks for your help guys i know it will be a pain to replace the lines or even finding one..will use vice grips..

[zerodameaon]

Then go down and get new fittings and a pipe flair tool at your local auto parts store. Don't reuse the old junk, you will thank yourself later.