PDA

View Full Version : Crush washer's part # for coolant banjo fittin's.......?????


Redtop_240
02-26-2004, 06:39 AM
Need to know what crush washers to use for a T25/T28 hybrid turbo......The coolant lines are leaking from the banjo fittin, and we have never had this problem so have no idea what crush washer to use on it......Does it have to be brass? or can we seal it with a brass washer and use some Red super high temp. RTV gasket maker? Like you would use on the thermostat housing? I know the turbo gets a lot hotter but we need to get this fixed this morning to get it to the shop for IC piping .........

Thanks in advance.......

-Jeff

Racer X
02-26-2004, 09:45 AM
any auto parts store in world has them, copper works fine or soft steal ones work too. nissan uses copper from the factoy. if you must have nissan ones go to dealer and z32tt turbo washers. if you like your turbo don't use rtv

epoxy_nc
02-26-2004, 01:26 PM
any auto parts store in world has them, copper works fine or soft steal ones work too. nissan uses copper from the factoy. if you must have nissan ones go to dealer and z32tt turbo washers. if you like your turbo don't use rtv


actually i live in a big town and cdouldnt find to seam a washer that comes close to fitting.

srboost240
02-26-2004, 01:42 PM
I searched every parts store in town also couldn't find any either because most places had a greater selection in standard sizes. I finally found some at napa but they were $3 for 2. If you're talking about the banjo fitting that goes into the block, I had to put some thermostat housing gasket maker between each washer, the block, and the end of the banjo bolt to get it to not leak.

s13srmadness
02-26-2004, 01:45 PM
15193-03E00
that's for the z32 washers. same thing. i just ordered a bunch.
oh, the E may be an "F", but it's an "E"... ha ha, cant read my own writing..
you can just put in the part number through nismoparts.com

autobahNESSA
02-26-2004, 04:15 PM
You can also use some teflone washers, that what i did. Their holding up fine.

Racer X
02-26-2004, 08:12 PM
if they say they don't have them tell them they are for brakes. i worked for auto zone i know they have them because i bought them a few times. also they are sometimes stocked in they row with help or motor mite products (help is brand for those that dont know.)

Redtop_240
02-26-2004, 09:48 PM
I finnaly found some brass washers at a mom and pops auto parts store......(14MM) but thank-you.....I had allready tried the Z32 idea but they had to order them I needed them this morning....we got the ones on the intake side of the turbo, but now thew outlet is leaking.................

Fuck-it..........

HAHA..........

thanks guys...