Tranny problem!!!

[Rps13Ed]

I'm trynna figure out a problem I had ever since I got my car running. When coming to a stop or driving around at 5 - 10 miles per hour my tranny shakes and chatters... I was told it was normal or that it could be cause of the CC stage 2 clutch... Or it could be since I have subframe solid mounts I'd need to do tranny mounts as well can I have zilvias input?

[KiLLeR2001]

Could possibly be loose pressure plate bolts. They don't need much torque to tighten but as a precautionary I like to apply threadlocker to them.

[Rps13Ed]

Tightened to spec and in star pattern

[godsmack]

Stage 2 clutch or twin plate? twin plate will have like a chinging sound. but i'm going to have to go with you have some bad mounts. and possibly the exhaust bracket that bolts to the tranny.

[Rps13Ed]

Stage 2 CC yeah I think both my motor mounts and tranny mounts are garbage

[godsmack]

you'll get alot of unwanted rocking with the tranny from bad mounts.

[fliprayzin240sx]

Id also check the driveshaft U-joint and center carrier.

[Rps13Ed]

Think if that's bad or not in place it will shake around?

[godsmack]

from the u-joint and center carrier it'll be more along the lines of vibration. with bad mounts there'll be more movement side to side especially if you rev the motor.

[Rps13Ed]

This shakes when coming to a stop... Or rolling ... 1-10 mph

[zerodameaon]

A Comp Clutch Stage 2 is not a twin plate. The subframe mounts transfer a lot of rear end noise into the passenger area, and if your diff lash is wrong that chatter will be very noticeable. This is another angle to look at not necessarily the correct fix for you.

[SharkMan]

Did you check your pressure plate bolts to see if they are torqued to spec?