PDA

View Full Version : Bride Zeta III cover on a Zeta II?

K!NCH
07-11-2012, 04:36 PM
I have an old Zeta II in my FC, and the cover is really worn out and beat-up. I was wondering the over from a newer Zeta III would fit since the designs are pretty similar, and that you can actually get replacements. I mean there might be a little modifying but I don't think it would be too bad.

Anyone try anything like this or know of anyone that has tried it? Also, I'm curious if this is a legitimate Bride or not. I got it for really cheap, and have always wondered. If it's not then I might just get a knock off and not worry about the cover...

http://sphotos-b.xx.fbcdn.net/hphotos-snc6/262033_10150297093817354_4551548_n.jpg http://sphotos-a.xx.fbcdn.net/hphotos-ash4/269876_10150284780427354_2167827_n.jpg
dazed
07-11-2012, 08:53 PM
The dimensions are different with zeta iii's being bigger. The color way you have is just OG, sorta uncommon I see them on Artis 2's on YAJ all the time.

But the replacement cover will almost certainly not fit your older seat.
K!NCH
07-12-2012, 01:39 PM
The dimensions are different with zeta iii's being bigger. The color way you have is just OG, sorta uncommon I see them on Artis 2's on YAJ all the time.

But the replacement cover will almost certainly not fit your older seat.

Thanks for the reply. Any suggestions for making it look better?
whiterps13
07-12-2012, 02:25 PM
Upholstery shop? Ide go that route if your attached to the seat.

Dont see too many old ones around these days.
EDacIouSX
07-12-2012, 02:51 PM
yea you can probably buy new bride fabric and have some of the cushions redone. not sure about the actual seat though.
K!NCH
07-12-2012, 05:08 PM
The seat itself is fine. It's just the fabric.

I'm also missing the plastic inserts for the harness goes.